H Max Power Barrow
Muck Truck H Max
The H Max Power Barrow has 450Kg capacity and a hydraulic tipping skip for the small builder, landscaper, ground worker and tree surgeon.
This power barrow has a load capacity of 450Kg and a massive 10CuFt volume (283 litres). The Muck Truck H Max power barrow still runs on the same engine and drive system as the original muck truck and max truck motorised wheelbarrows as this system has been tried and tested. This power barrow is slightly wider than the standard muck truck and max truck power barrows (26mm or 1inch), measuring in at just 736mm (29 inches) in width, but still designed to travel through a narrow side gate and get to the the back of gardens and buildings for removing soil, broken concrete, slabs, garden waste, etc.
The skip of the H Max is 1,828mm (72 inches), making it that little bit easier to load when working in conjunction with an 08-micro digger when being loaded using a grading bucket or similar, speeding up the movement of soil for the builder or landscaper. The wheelbase of the H Max is the same as the muck truck power barrow, so it works with the same loading ramp. The structural design of the loading skip means that the ball hitch attachment will fit all the Muck Truck models. This power barrow has a height of 1,066mm (42 inches) and a weight of 184kg.
A flatbed attachment is also available. The H Max power barrow flatbed has extended sides for handling wider loads. Current attachments and upgrades available for this powered barrow are the twin front wheels, turf tyres also known as grass tyres and skip mounted towing ball hitch fitting which can be removed so it can be used as a clevis or drop pin connection. The on-board hydraulic system of this power barrow is one of the two main differences from the max dumper and muck truck barrows as well as the half ton loading capacity. The hydraulic system has three spool valves, the first lever is to operate a tilt ram which fixes to the underside of the skip to control the tip hydraulically, very useful when part load tipping or just normal load tipping. This is beneficial when used with the ramp and loading into a skip, then simply return the power barrow skip into its normal working position by operating the lever. The 2nd and 3rd hydraulic spoil valves come with levers but not mounted until needed. The extra hydraulic valves are necessary to operate some of the other barrow attachments which will be available in the future, such as the snow plough, power lifter, power brush etc.
Speed: 0-3.5 mph
Fuel: Unleaded petrol
Noise rating: 79 db
Parking brake: Disk
Wheels: Front and rear 400x10, 4 ply tractive
Dimensions: L72" (1829mm)/W29" (737mm)/H42" (1066mm)
Traction: 4-wheel drive
Call us on 0333 880 6654 for more information or a quotation.